How Do You Replace a Water Pump in a 1995 Toyota Camry?

I do not know how YOU do it, but as for ME, I hire a mechanic

1. Would it hurt my water pump if installed a second water pump on the output of the first?

In theory, there should be no problem installing multiple pumps in series. However, to do so, the pumps must both have the same flow rate. If the pumps are matched, then the head pressure should be additive. In practice, it might be more complex than it sounds.The common solution to this problem, is to install a pressure tank. While this might seem like an expensive solution, it may actually not be so bad. If you were considering installing multiple small pumps throughout the home, you might find that a single pressure tank is not far off price wise. If you are considering installing a pump matched to the well pump, you still might find that the pressure tank option is cheaper. This is especially true, if you consider the electrical requirements of the second pump. Something like the below will theoretically work, but will require three pumps and some new plumbing

2. Why does my water pump have oil all over it?

STUPID ANSWERS, these answers sound like ****, something a rip off shop would say. 1- buy engine degreaser, and go to the car wash or in the drive if you want to. 2- let the car warm ou, then turn it off and spray the degreaser every where theres oil and dirt. 3- Let stand about 10mins 4- turn the engine back one and use the pressured water (CAR WASH) to wash off the cleaner. You might have to repeat the soaking a few times depending on how long its been leaking. 5- once clean, you can either just let it idle in the drive way or go drive around alittle to see if you can get the oil leak to start again to see where its coming from. Once you find the leak either fix it or just take it to a respectable shop and get a quote for the repair. Dont start assuming that theres a huge problem. It sounds like its just the valve covers, but theres afew possible things that could leak on it. Do this and it will help you find any possible leaks.

3. A water pump is run by an electronic motor with a power rating of 750W...?

The motor has a maximum power output of 750-watts. Since 1 watt = 1 Joule/sec, this is 750 Joules/sec. Now the work done in raising 1.48 kg. over a vertical distance of 37 m. against the force of gravity is: 1.48 Kg. x 9.81 x 37, since Work Done = Force x Distance; Force = mass x "g"; g = 9.81 m/s. Hence, the Work Done = 537.2 Joules/ sec. This is the 'useful energy output', which, by definition, is the amount of energy that the pump & motor combination actually uses. With the data provided, it is not possible to calculate the efficiency of the water pump alone.

4. how much is the normal price for a water pump to be replaced?

It would help if you could provide the year, make, and model of the vehicle you are inquiring about. The price can vary WIDELY depending on the vehicle. Edit: On a '97 Nissan pickup, assuming you have the 3.0L SOHC V6 engine, you are looking at about anywhere between 4 to 6 hours labour, plus the cost of the parts. You may as well replace the timing belt as well as the other belts, since they all need to be removed for access to the water pump on this particular vehicle. Hope this helps.

5. How hard is it to change a water-pump on a 2001 Silverado V-8?

If your engine is a 5.3L, then these are it. May be similar to the other v-8's as well. Also says about 2 hours to do it. Course that would be mechanic time. Water Pump Replacement Removal Procedure Drain the cooling system. Loosen the air cleaner outlet duct clamps at the following locations: Throttle body Mass airflow/intake air temperature (MAF/IAT) sensor Remove the radiator inlet hose clip from the outlet duct. Remove the air cleaner outlet duct. If necessary, remove the engine sight shield. Remove the radiator vent inlet hose from the radiator hose clips. Reposition the inlet hose clamp at the water pump. Remove the inlet hose from the water pump. Remove the fan blade. Remove the accessory drive belt. Reposition the outlet hose clamp at the water pump. Remove the outlet hose from the water pump. Reposition the surge tank outlet hose clamp at the water pump. Remove the surge tank outlet hose from the water pump. Reposition the heater inlet hose clamp at the water pump. Remove the heater inlet hose from the water pump. Remove the water pump pulley bolts and pulley, if required. Remove the water pump bolts. Remove the water pump and gaskets. Discard the water pump gaskets. Installation Procedure Important: All gaskets surfaces are to be free of oil or other foreign material during assembly. Install the water pump and NEW gaskets. Notice: Refer to Fastener Notice in Service Precautions. Install the water pump bolts. 2.1. Tighten the water pump bolts a first pass to 15 Nm (11 ft. lbs.) . 2.2. Tighten the water pump bolts a final pass to 30 Nm (22 ft. lbs.) . Install the water pump pulley and bolts, if required. 3.1. Tighten the water pump pulley bolts a first pass to 10 Nm (89 ft. lbs.) . 3.2. Tighten the water pump pulley bolts a final pass to 25 Nm (18 ft. lbs.) . Install the heater inlet hose to the water pump. Position the heater inlet hose clamp at the water pump. Install the surge tank outlet hose to the water pump. Position the surge tank outlet hose clamp at the water pump. Install the outlet hose to the water pump. Position the outlet hose clamp at the water pump. Install the accessory drive belt. Install the fan blade. Install the inlet hose to the water pump. Position the inlet hose clamp at the water pump. Install the engine vent inlet hose to the radiator hose clips. If necessary, install the engine sight shield. Important: Align the arrow at the throttle body end of the duct with the throttle body attaching stud. Install the air cleaner outlet duct. Install the radiator inlet hose clip to the outlet duct. Tighten the air cleaner outlet duct clamps at the following locations: Throttle body MAF/IAT sensor Tighten the air cleaner outlet duct clamp screws to 7 Nm (62 inch lbs.) . Fill the cooling system.

recommended articles
Ask Smithy: Automotive Advice
GOT car problems? Graham Smith can help.Diesel's having a pink fitIn my 2007 Nissan Navara, the 2.5-litre turbo diesel stutters or hesitates and makes a pinking noise when it's cold but it's OK when it's warm. I have had it to two mechanics and they couldn't fix it. What do you think is wrongKevin RomanoCheck the injectors. Your problems are most likely there. --Just handle ItHow can I improve the handling of my 2010 Nissan MaximaAndrew, emailNissan specialist Jerry Newman is horrified at the thought of trying to improve the handling of the Maxima. He believes it handles well as it is and is better left alone. If you were to seek to improve the handling, you could fit uprated springs and struts but this would be expensive. Use quality components from the likes of Pedders. Perhaps you could check the web for components used in Japan but you must understand that whatever you do will have a detrimental effect on the car's ride and you might not improve the handling much anyway. --Annoying LeakMy Subaru Outback 2.5 EFI has developed a slow leak at the rear of the engine between the head and the block. I have had it pressure tested and that's the only place it's leaking from. It doesn't overheat and there are no bubbles in the radiator or water in the oil. I have had the water pump, radiator hoses and radiator checked and there are no leaks. I have had three independent reports by mechanics that say the same thing. To fix the problem, it's necessary to pull the motor out and I have been quoted $2800 to $4800 to do it. It has done only 176,000km and I am pretty dirty at having a head gasket go at this relatively early stage. Any suggestions for a fixAlan, emailI would try Bars Leaks or a similar product and hope it seals the coolant leak. To replace the gasket, which is the best fix, you would have to take the engine out as the mechanics suggest. --No Cruise ControlLast year my 2004 Renault Megane Turbo Sports started to play up with a miss in the engine when at a constant speed. It's not there on acceleration, only when cruising. I have had four mechanics check it. They changed the alternator and the exhaust sensor, the injectors were cleaned three times, new spark plugs were installed, it had the vacuum test and a camera up the exhaust pipe. One said it was a sticking exhaust valve but that would cost $4000 and it might not fix it! What can I doWarren, emailYour description of the problem suggests it is not an ignition problem. I would be investigating the fuel side of the equation, looking for things that might be making it lean at low throttle openings as you would be when cruising. Is there an air leak that is affecting the mixture strength, or something like that Having said that, it could be a sticking valve as the mechanic has diagnosed. --Towing The LineWhat would be the safest towing load for my 2002 Nissan X-Trail auto 2.5, and what would be the safest and best towing set-upGordon McCarthy, emailNissan rated the X-Trail to tow 2000kg with trailer brakes, so you should be able to safely tow up to that weight. --Engine FailureI have a 2009 Nissan Navara 2.5 diesel and I am concerned about the stories I have read of these motors failing anywhere from 60,000km to 120,000km. I have also read about the timing gear failing. Have you heard anything about this and if it's true what can I do to prevent itPhil Harrison, e-mail.There are reports of engines failing but these evidently were not serviced by the book. It is important to religiously service the Navara, and use the Nissan recommended oil. The failures we have heard about are mostly failures of the camshaft and cam timing gear, which have led to more serious damage.Originally published as
What Are the Holes Which Are Found in an Engine Block?
10 Best RV Battery Monitors Reviewed and Rated in 2021 - RV Web
2002 Ford Focus Water Pump Or Heater Core?
What Type of Coolant Should I Use for 2004 Toyota Sienna?
Does Anyone Know How to Change a Water Pump on a Benz 190e?
Surrender at the Water Pump at Wind River Indian Reservation
Best Honeywell Water Pump for Evaporative Cooler CL201AE
What Is Wrong with My Car?
2005 Passat Flashing in Red " STOP" and a Little Water Or Gage on Left Starts Flashing When Idling?
related searches
Ask Smithy: Automotive Advice
10 Best RV Battery Monitors Reviewed and Rated in 2021 - RV Web
2002 Ford Focus Water Pump Or Heater Core?
What Type of Coolant Should I Use for 2004 Toyota Sienna?
Does Anyone Know How to Change a Water Pump on a Benz 190e?
Surrender at the Water Pump at Wind River Indian Reservation
Best Honeywell Water Pump for Evaporative Cooler CL201AE
What Is Wrong with My Car?
2005 Passat Flashing in Red " STOP" and a Little Water Or Gage on Left Starts Flashing When Idling?

Copyright © 2020 Concises YuGa Sports | Sitemap