Car still Overheating with a New Water Pump, Thermostat?

If your fan is operating.. check to see if the water is circulating. Leave the cap off the radiator and bring up to temp..If it is not, you may have a vapor lock in the system, and will have to bleed the air out.

1. Water pump belt broke on a 99 cougar 2.5 V6?

the v6 engine works using a timing chain, rather than a belt, so it should not break and doesnt need replaced every 60,000 miles like a belt does. my main concern would be heat damage, as if the water pump was unable to function heat will have been allowed to build up and this can cause some serious damage to the internals of the engine. this could be the cause of the starting problem. on the simpler side though, iirc the alternator works off the same belt as the water pump....if the belt wasnt turning the alternator then the battery will become flat due to not being charged. test the battery, and if its showing under 12 volts then its flat. hope thats been of some help to you...all the best x

2. why does my water pump turn on and off?

Does it have a resevour that it pumps to? If so, when it get full it will shut off, and when the water level gets low, it comes on

3. Anyone know a place where I can get a water pump for cheaper then what I was told?

Hi the price of the water pump that your mechanic quoted sounds about right.It's the labour charge for the removal and replacement of the pump and coolant and final adjustments that knocks up the final price.Best of all if it the pump breaks before 12 months it would be covered under warranty.

4. Can the transmission have problems if I have a leaky water pump?

Heres your problem, you drive a mercury

5. I had installed water pump & more.?

sad, i have bad news, those engines have all the same problem, you will have to overhauled complete if you want it right. So , either you sell it , or start to get an estimate for a new short block. Believe me do not spend more money $$$ , the job have to be complete , if not you are wasting time and your hard earned dollars. The ford escort have similar issues, after 120k the engine is a time bomb. i would suggest every ford owner to dilute the coolant mixture , the more water - the less antifreeze the better

6. what is a reasonable charge for replacing a water pump on my 2006 toyota camry with 40k miles?

Rear for that miles, but total cost for job for 2006 is $325.00

7. What is another common reason for coolant leaks besides water pump on an eclipse?

could be the engine end of the upper radiator hose dripping down in that area

8. Should I buy a $30 water pump for my '96 Cadillac?

in simple terms stick to the ideal heater hose to the engine block you will see the water pump housing.Be stated which you do no longer replace the water pump on a Northstar engine.You rebuild them.a particular gadget is needed to eliminate the water pump itself from the housing. It costs someplace interior the community of $20

9. Car Part | What is a Water Pump and How does it Work ?

A water pump is a device that is found in motor vehicles like cars, trucks, buses, and trains. This pump distributes the heat that is produced by internal combustion engines. The heat is actually the end form of wasted energy produced when these motor engines work. Without the water pump, the heat can build up inside the engine causing the engine to overheat. If this process continues, the engine will eventually be destroyed. In simpler terms, a pump keeps the temperature at acceptable levels by dissipating the heat. It is crucial to have a proper functioning water pump in every vehicle and this is why every automobile users need to know about water pumps. What Does a Water Pump Look Like? The water pumps look like a disc. It has a circular shape and is made of a combination of steel and aluminium. The inner part of this device is also circular with chambers. A spindle is located in the middle with several protrusions which look like a paddle for small boats. Where is the Water Pump Located in a Car? It is usually found in front of the car, which is normally in front of the engine. It can be bolted against the engine or on the mounting of the engine. Keeping the water pump bolted will keep it in place even during rough drives. A hose is used to connect this device to the radiator. At the same time, another set of hoses is used to connect the pump to the engine in a closed circuit. A fan belt is then utilized to connect the central spindle of the pump to the engine output. The fan belt only turns when the engine is running. At this point the central spindle of the pump also turns. When the central spindle turns, the paddle-like protrusions also turn and utilize the centrifugal force, it creates suction. This allows the pump to get water from the radiator and then sends it to the engine via the hoses. The water then absorbs the heat being generated by the engine and goes back to the radiator where it is cooled. The water pump which plays a crucial role in the cooling of the surrounding components is normally composed of six blades and can also increase the flow of coolant by attaching a shroud to the bottom of the impeller, although this depends on the kind of car. To ensure a long life, the water pump must be designed and manufactured precisely to minimize friction and resistance while maximizing the flow. What is the Purpose of a Water Pump? At the most basic level, a car's water pump is essentially the heart of the cooling system. Its purpose is to continuously circulate engine coolant throughout the cooling system. The cooling system runs from the radiator to the engine and back to the radiator. It is the system which allows drivers to enjoy a nice comfortable, cool car ride. The pump is powered by the engine and typically operates through a belt and pulley system, although a gearing chain could be used as well. The most important component of a pump is the impeller. The impeller's job is to spend and circulate the cooler throughout the car. Visually it is similar to a propeller that makes a boat move. The impeller can only be effective when it operates on a sealed bearing. If the seal bearing begins to leak then the water pump will quickly wear out. What many people do not know is a vehicle's water pump has a weep hole. There are two holes in the water pump's casting which are referred to as weep holes. The top weep hole acts as an air vent which allows air to evacuate the casting system and prevent a build-up of humidity around the bearing. It also leverages atmospheric pressure to keep the seal intact. The lower weep hole exists to allow any fluid which is collected around the pump to drain out. This protects the integrity of the bearings. If a pump fails it is most often because a seal failed, not because the impeller has stopped working. There are several variables which typically cause premature seal failure. The most common is high temperatures. Mechanical seals rely on spring-loaded assemblies to ensure the carbon seals remain intact. If the engine consistently runs hotter overseas it may disintegrate the rubber parts. Electrolysis is another common cause of pump failure. It creates a film or crystallization over the seal face which will allow moisture to enter the weep chamber. The final common reason a water pump will fail is because of additive gels. There are a number of chemical additives on the market designed to promote good cooling system health. Unfortunately, many of these gels actually damage the seal around the pump. How to Replace the Water Pump Once the water pump is damaged, it is crucial for you to get a new one for replacement so as to ensure the proper working of your car. Below are the essential steps which would assist in replacing the water pump appropriately. The first thing that you have to do is to find a water pump that is suitable for your car. Then, you should turn off the engine of your car. Make sure that the engine has cooled down completely when you are about to start replacing the pump. Then you should locate the car battery. In this case, make sure that you disconnect the battery's ground. The second thing that you have to do is to set up a drain pan beneath the engine. Then, you should drain the contents of the cooling system. In this case, you should make sure that the cooling compartment is perfectly drained. The third thing that you have to do is to find the alternator mounting brackets. Then you should loosen them to remove the drive belts. To unfasten them, you can use sockets with the appropriate size and lift them away. Then, you should clear any clutter or accessories out of the water pump's path. Then, you should access it by removing the pulley, fan and fan shroud of the engine. After that, you should disconnect the hoses of the water pump. To do this, you can use a socket or wrench. You should loosen the screws and remove the water pump from the engine. Place it away from your work area. Look at the engine block and perform an inspection to it. You should clean it up if it needs cleaning by using a rag. The fifth thing that you should do is to change the gaskets of the water pump if you find that they are damaged or broken. Then, you should line up the new water pump and place it in the old previous place of the old pump. In doing it, you should consult the manual to double-check so that you can do the correct thing. Then, you need to bolt the water pump at a certain pressure properly. The next thing that you should do is to reconnect the water pump hoses. You should also put anything else that you have removed back. In this case, you have to make sure that the belts are properly adjusted to the car's tension specifications. The last thing that you should do is to refill the car cooling system. In this case, you can upgrade to a better coolant product or antifreeze. Then, you should plug the battery back and start your car. Make sure that you perform an inspection in order to ensure you that everything is running well. With these you will be able to replace your water pump appropriately. In the wrecking industry it is very common to get asked for a second hand water pump, especially if its a super expensive one like a electronic one of a BMW, my advice to you is to always buy water pumps brand new, if they are to expensive new genuine you can always try place like HSY auto parts, Imparts, Welch or Unique Auto Parts. If you have more main stream vehicles like Ford, Holden or Hyundai you can find cheaper options at big franchise companies like REPCO or BURSONS.

recommended articles
Ask Smithy: Automotive Advice
GOT car problems? Graham Smith can help.Diesel's having a pink fitIn my 2007 Nissan Navara, the 2.5-litre turbo diesel stutters or hesitates and makes a pinking noise when it's cold but it's OK when it's warm. I have had it to two mechanics and they couldn't fix it. What do you think is wrongKevin RomanoCheck the injectors. Your problems are most likely there. --Just handle ItHow can I improve the handling of my 2010 Nissan MaximaAndrew, emailNissan specialist Jerry Newman is horrified at the thought of trying to improve the handling of the Maxima. He believes it handles well as it is and is better left alone. If you were to seek to improve the handling, you could fit uprated springs and struts but this would be expensive. Use quality components from the likes of Pedders. Perhaps you could check the web for components used in Japan but you must understand that whatever you do will have a detrimental effect on the car's ride and you might not improve the handling much anyway. --Annoying LeakMy Subaru Outback 2.5 EFI has developed a slow leak at the rear of the engine between the head and the block. I have had it pressure tested and that's the only place it's leaking from. It doesn't overheat and there are no bubbles in the radiator or water in the oil. I have had the water pump, radiator hoses and radiator checked and there are no leaks. I have had three independent reports by mechanics that say the same thing. To fix the problem, it's necessary to pull the motor out and I have been quoted $2800 to $4800 to do it. It has done only 176,000km and I am pretty dirty at having a head gasket go at this relatively early stage. Any suggestions for a fixAlan, emailI would try Bars Leaks or a similar product and hope it seals the coolant leak. To replace the gasket, which is the best fix, you would have to take the engine out as the mechanics suggest. --No Cruise ControlLast year my 2004 Renault Megane Turbo Sports started to play up with a miss in the engine when at a constant speed. It's not there on acceleration, only when cruising. I have had four mechanics check it. They changed the alternator and the exhaust sensor, the injectors were cleaned three times, new spark plugs were installed, it had the vacuum test and a camera up the exhaust pipe. One said it was a sticking exhaust valve but that would cost $4000 and it might not fix it! What can I doWarren, emailYour description of the problem suggests it is not an ignition problem. I would be investigating the fuel side of the equation, looking for things that might be making it lean at low throttle openings as you would be when cruising. Is there an air leak that is affecting the mixture strength, or something like that Having said that, it could be a sticking valve as the mechanic has diagnosed. --Towing The LineWhat would be the safest towing load for my 2002 Nissan X-Trail auto 2.5, and what would be the safest and best towing set-upGordon McCarthy, emailNissan rated the X-Trail to tow 2000kg with trailer brakes, so you should be able to safely tow up to that weight. --Engine FailureI have a 2009 Nissan Navara 2.5 diesel and I am concerned about the stories I have read of these motors failing anywhere from 60,000km to 120,000km. I have also read about the timing gear failing. Have you heard anything about this and if it's true what can I do to prevent itPhil Harrison, e-mail.There are reports of engines failing but these evidently were not serviced by the book. It is important to religiously service the Navara, and use the Nissan recommended oil. The failures we have heard about are mostly failures of the camshaft and cam timing gear, which have led to more serious damage.Originally published as
What Are the Holes Which Are Found in an Engine Block?
10 Best RV Battery Monitors Reviewed and Rated in 2021 - RV Web
2002 Ford Focus Water Pump Or Heater Core?
What Type of Coolant Should I Use for 2004 Toyota Sienna?
Does Anyone Know How to Change a Water Pump on a Benz 190e?
Surrender at the Water Pump at Wind River Indian Reservation
Best Honeywell Water Pump for Evaporative Cooler CL201AE
What Is Wrong with My Car?
2005 Passat Flashing in Red " STOP" and a Little Water Or Gage on Left Starts Flashing When Idling?
related searches
Ask Smithy: Automotive Advice
10 Best RV Battery Monitors Reviewed and Rated in 2021 - RV Web
2002 Ford Focus Water Pump Or Heater Core?
What Type of Coolant Should I Use for 2004 Toyota Sienna?
Does Anyone Know How to Change a Water Pump on a Benz 190e?
Surrender at the Water Pump at Wind River Indian Reservation
Best Honeywell Water Pump for Evaporative Cooler CL201AE
What Is Wrong with My Car?
2005 Passat Flashing in Red " STOP" and a Little Water Or Gage on Left Starts Flashing When Idling?

Copyright © 2020 Concises YuGa Sports | Sitemap